3 phase transformer on-load tap changer testeris mainly used to test three-phase transient time, transition waveform, transition resistance, synchronization state, etc. The transformer on-load switch tester is a comprehensive transformer on-load switch measurement and tester, which is used to measure and analyze the electrical performance indicators of power transformers and special transformers on-load tap-changers. The transformer on-load switch tester can automatically capture and display the transition resistance during the transition process. There is also a process of time jumping.

Technical parameters ：

Three phase constant current source charge,charge current: 3A/1A; 0.6A/0.2A

Maximum voltage of the port: 24V

Maximum range of transition resistance: 100Ω

Measuring range: 1A：0.4Ω～20Ω 0.2A：10Ω～100Ω

Record time of waveform:300ms

Sample rate: 30k

Resolution of time:0.1ms

Resolution of resistance: 0.1Ω

Accuracy of transition resistance: ±5% Reading±0.1Ω

Accuracy of transient time: ±0.5% Reading±0.2mS

Temperature: -10-40℃ Humidity: <85%RH

3 Phase Transformer On-load Tap Changer Tester

Feature ：

1. The transformer on-load tap changer tester has good anti-interference performance. The all-aluminum alloy case and the tester are equipped with power supply noise filters and anti-interference circuits, which can be used in poor power supply and strong electromagnetic field interference. Reliable measurement on site, direct display of resistance value; automatic analysis of waveform failures and mark failures. Automatically adjust the resistance value and time range according to the sampled data

Franco Califano Forum

© 2002 Franco Califano Fans Club